Joint d'étanchéité du piston AeroPress

My old seal was getting so worn that pressing felt uneven, but this one restores that tight, consistent pressure right away. The fit into the plunger was perfect, no wrestling or trimming needed.

My old one had gotten so loose that coffee was leaking past the plunger every brew, but this replacement seals up tight and I'm finally getting that consistent pressure again. The rubber feels a bit firmer than the worn-out one, but it fits the chamber perfectly and gives a satisfying resistance on

Fitting this new seal took about 30 seconds and the plunger slides smoothly but locks in tight enough that I can feel the pressure building right away. Brewing's consistent again, cup after cup, just like when the press was brand new.